Introduction to buttons on the remote control
3} Fan Button
This button is used for setting Fan Speed from AUTO to
...111111,
to ..,.111111 to ...allll
i,
then back to Auto.
* In AUTO mode fan speed will alternate between Low, Medium or High based on your ambient
4} _. /
T
Button
Press • / T button to increase/decrease the set temperature. In AUTO mode, the set tempera
ture is NOT adjustable.
When setting Timer On or Timer Off, press • or T button to adjust the time.
5} Swing Button
Press this button to change the swing angle of the air louver to direct airflow.
6} Sleep Button
Under Cool or Heat mode, press this button to turn on the Sleep function. In Sleep Mode the pre
set temperature will increase by 2 degrees {Cool Mode) or decrease by 2 degrees {Heat Mode)
after 2hours from setting. Press this button again to cancel the Sleep function.
* Under Fan Dry and Auto modes, this function is unavailable.
7} Temp Button
Press this button to see the indoor set temperature, indoor ambient temperature on the indoor
unit's display. The setting on remote controller is selected circularly as below:
r
no display _____.
Q \
\___ QJ ._
[D .___)
• When selecting the
II
Q
II
the display will show the set temperature. This will be displayed
on both the indoor unit and the remote control.
• When selecting the
II
a}
11
the display will show the ambient indoor temperature. This will
be displayed on both the indoor unit and the remote control.
• When selecting the
II
Q
6
11
the display will show the outdoor temperature. This will be dis-
played on both the indoor unit and the remote control.
Note:
Outdoor temperature display is not available for some models. At that time, indoor unit receives
11
Q
6
11
signal, while it displays indoor set temperature.
8} Turbo Button
Press this button to activate / deactivate the Turbo function Under COOL or HEAT mode.
© 2018 EcoAir
7
All rights reserved