ECO Spot
TM
LED40 User Manual
Copyright © 2014 Sunhope Inc
Page
1
of
4
Thank you for choosing our ECO Spot
TM
LED40 Gobo Projector (SKU: ES-LED40). This
unit is equipped with a fan cooled 40W High Power LED. It is also available as
exterior version (ES-LED40E).
Please read this manual before installing or operating this fixture, follow the safety
precautions listed below and observe all warnings.
Package Contents
•
Projector with power cord and integrated gobo holder and rotator
•
Spare gobo retaining ring and spare drive belt
•
Test Gobo
•
Gobo adapter for D- to E-Size gobos with retaining ring (ES-LED40 only)
Safety Information
•
Place your fixture at a suitable place with good air flow.
•
Keep flammable materials away from the fixture.
•
Minimum distance to flammable material = 1 ft (0.3m).
•
Minimum distance to illuminated surface = 3.3 ft (1.0m).
•
Provide a minimum clearance of 4 in (10cm) around air vents.
•
Use only genuine spare parts for part replacement.
•
Do not look directly into the lamp; it can result in eye damage.
•
Don’t touch the hot surface during operation, use gloves if necessary.
•
Always unplug the unit from the power mains before any service is done.
•
Allow 20 minutes to cool down before servicing the unit.
•
Replace Lamps only with the same type other lamps may cause damage.
•
Light fixtures should be installed and maintained only by qualified personnel with experience in lighting
equipment and general electrical experience.
Electrical Safety
•
Disconnect the fixture from AC power before handling the fixture.
•
Always ground (earth) the fixture electrically.
•
Use only a power source that complies with local building and electrical codes and has both overload and
ground-fault protection.
•
Do not use the fixture if the power cable or power plug is in any way damaged, defective or wet, or if they show
signs of overheating.
WARNING! Select the correct Line Voltage with the selector on
the back of the unit before Operating.