866.463.2611 • www.ecosystemsdisplays.com
Setups
Order #XXXXX - ECO-42C Sustainable Counter / Podium
Counter Top
When assembled
1.5” standoff
barrels
standoff
caps
standoff
caps
1.5” standoff
barrels
4.5” standoff
barrels
Transformer
hole for wire
management
To
Power
Note:
No standoff
cap for
middle
barrel.
Steps:
1) Connect horizontals [17,17A] between
verticals [18,18A], sliding backer panel between
verticals. See
CEI-110 Corner Connection
detail.
2) Attach left & right cabinets to frame
assembly [17/17A/18/18A] using bolts & wing nuts.
3) Install
Counter Top
to assembly using standoff
barrels as shown.
See
Standoff Barrel Attachment
detail.
4) Connect power cords to Supernova lights as shown.
5) Apply SEG graphic to frame.
*
*
*
*
17
17A
18A
18
Item
17/17A
18/18A
Qty.
1/1
1/1
Description
46”w CEI110 Horizontal Extrusion
30.5”h CEI110 Vertical Extrusion
CEI-110 Corner Connection
*
1) Insert TSRV2 and A1 Brackets
into milled groove of extrusion.
2) Slide connecting extrusion over
exposed end of brackets.
3) Use Set screws to secure
extrusions.
4) Use Set screws to secure
extrusions.
TSRV2
Bracket
A1
Screws
Graphic Removal
To remove the graphic from
the frame, locate the fabric
pull tab. Gently pull up on the
tab to remove the fabric.
Step 1
Insert corner A. Turn edge of
graphic so silicon welt is
perpendicular to face of
graphic. Insert narrow side
of welt with fabric to outside
into the channel. Repeat for
other side of this corner.
Step 2
Repeat Step 1 for opposite
corner C, then insert corner
B, followed by corner D, to
complete the installation of
the corners.
Step 3
Once all corners are inserted,
press one silicon edge into
channel from corners and
work toward the center.
Make sure welt is fully inserted
into channel. Continue until
all sides are done. Smooth
out edges of graphic.
SEG Graphic Installation
It is important to first insert
graphic into each alternate
corner then to the sides of
the frame. If this is not done,
graphic will not fit into the
frame correctly.
Corner A
Corner D
Corner B
Corner C
* * *
Slide V4 connector into
horizontal groove of
extrusion; tighten set
screw to secure.
Connect Standoff Barrel to V4.
V4
set
screw
standoff
barrel
Standoff Barrel Attachment
*
+
-
Power
Female
Transformer
Light to Tranformer Attachment
+
+
-
-
Lights
Male
Light to Light Attachment
Maximum of 7 lights per chain,
9 lights per Transformer
Backer Panel
TOP VIEW
CEI110
bolt &
wing nut
Lights
Backer
FRONT
