Smart 3pA Page 6
2.3 Attaching the sensors
The Sensor is in two parts and one is clipped around each of the three live cables.
Press the side clips of the sensor to separate the two parts.
Place it around the cable.
Click shut
- do not force the sensor shut around a cable that is too big as
this could damage the sensors inner core.
If the sensor will not easily fit round the cables you’re trying to monitor then you may be trying to
attach it to an armoured or multi core cable.
The faces of the sensor must make a flat contact.
The sensors are designed to be a loose fit around the cables.
Use the live cable tester if you’re in doubt as to the whether you’re connected to
the live cables.
Fit the tester to the end of the sensor – the LED will illuminate if the cable being
monitored is live.
Remember to remove this tester before continuing set up.
The sensor may buzz, if not connected to the transmitter.
