ECM Manufacture 89250, Руководство пользователя

Страница: 33 / 38

ENGLISH
Translation of the original German user manual
32
Problem Possible Cause Troubleshooting
The coffee shaft or the coffee
funnel are blocked with ground
coffee.
The grind is too fine.
Adjust the grind to a coarser
degree.
The humidity inside the funnel is
too high.
Please make sure that the grinder
is not placed too close to the
steam wand of the espresso
machine.
Coffee pours out too fast into the
cup.
The grind is not fine enough. Adjust the grind to a finer degree.
The amount of ground coffee is
not enough. Use more coffee.
→
Increase
grinding time
Not enough tamping pressure
Use more pressure when
tamping.
Sparse coffee dispensing, only
drop by drop
The grind is too fine
Adjust the grind to a coarser
degree.
There is too much ground
cofffee. Use less ground coffee.
→
Reduce grinding time.
Too much tamping pressure Use less pressure when tamping.
Little or no crema on top of the
coffee
The grind is not fine enough. Adjust the grind to a finer degree.
Coffee too old Use fresh coffee.
The amount of ground coffee is
not enough. Use more coffee.
→
Increase
grinding time
The beans are improper Use another type of coffee bean.
The bracket of the grind level
adjuster has become loose/ The
grind setting has changed
autonomously.
Vibrations during grinding have
loosened the bracket.
1. Switch the grinder off and
unplug the electrical cord.
2. Loosen both screws (2.5mm
Allen wrench), that are, or
were, holding the grind
adjustment bracket.
Position the bracket as close to
the gear wheel as possible and
tighten both screws again.
The grinder motor does not
operate.
On/Off switch is positioned to
„Off“.
Switch On/Off switch to position
„On“.
Motor grinder is too hot.
→
Grinder is automatically
switched off by the over-
temperature protection
Let the grinder cool down.
Have several kilograms of coffee
been ground?
Is the grind too fine causing the
burrs to block each other?
Unequal grinding quantities.
Lock slide of the bean hopper is
not completely open.
Open the lock slide.
Bean hopper is not evenly filled.
Make sure that the bean hopper
is evenly filled.
The burrs have not been broken
in yet. Over time, and usage, the grind
will become stabilised.
8 CE CONFORMITY
Conformity
This product complies with the following directives:
•
Machinery Directive 2006/42/EG
•
Low Voltage Directive: 2014/35/EU
•
Directive for electromagnetic compatibility (EMC): 2014/30/EU
•
Directive on the restriction of the use of certain hazardous substances in electrical and electronic
equipment (ROHS): 2011/65/EU
•
Directive 2012/19/EU regarding waste electrical and electronic equipment
-(WEEE Reg.-Nr.: DE69510123)