ADVANCED PROGRAMMING INSTRUCTIONS
7. If using a multi channel remote, select required channel by using the ‘Left or Right’ channel selection
buttons on the remote. If using a single channel remote, proceed to Step 8
8. Press Set button on motor until motor jogs. Press the ‘Up’ button on the remote, motor will jog
3. Press Prog button, release when light shows
4. Press Prog button again, release when light shows
5. Press Prog button and hold until light shows twice
6. Press Prog button and hold until motor jogs twice
1. To start you will need an installed motorised blind, remote
control and push pin/paperclip/pen.
2. Make sure when fitting the blind into the brackets that the
SET button & charge port are facing downwards.
9.Using the remote, check that the motor is turning in correct direction. If motor direction does not need
adjusted proceed to step 11 . If direction needs changed, follow step 10.
10. Press Stop button on remote for approx. 5s, motor will jog. Press the ‘Down’ button on the remote, motor will jog
Single
Channel
- Up
- Stop
- Down
- Channel Selection
INITIAL SET UP
PROGRAMMING INSTRUCTIONS
LINK REMOTE TO MOTOR
MOTOR RESET
SET BUTTON
CHANGING MOTOR DIRECTION
Six
Channel
Sixteen
Channel
SWITCHING MOTOR ON/OFF:
To switch off:
1. Press and hold the Set button on the motor until the red light
flashes 3 times
(please note motor will jog after approx. 2s while
holding the set button)
, motor is now switched off
To switch on:
1. Press the Set button on the motor until the red light flashes,
motor is now switched on
SETTING MULTIPLE BLINDS ON ONE CHANNEL:
If blinds have been pre-programmed already follow these steps:
1. Select the desired channel on the remote
2. Press the set button on the motor until the motor jogs
3. Press the up button on the remote, motor will jog
4. Repeat steps 2 & 3 for all other blinds to be set on this channel
(Please note: blinds already set on this channel may react to the press of
the up button during step 3)
If blinds are being programmed for the first time
follow these steps:
1. Using instructions above switch off all motors that are to
be programmed on the same channel,
leave just one motor to be programmed switched on
2. Select the desired channel on the remote
3. Follow basic programming instructions for linking remote,
checking direction & setting limits
4. On completion of programming, switch blind off as per
instruction above
5. Switch on next blind to be set on this channel
6. Repeat steps 3-5, repeat this process for all other blinds
to be set on this channel
(Please note: Once all blinds have been individually programmed
ensure that all motors are switched back on)
SWITCHING BETWEEN DOT MOVEMENT AND CONTINUOUS
MOVEMENT:
1. Press the Set button on the motor until the motor jogs once
2. Press the stop button on the remote, the motor will jog once
3. Switch between Dot & Continuous movement is complete
1
SET BUTTON
Up
Stop
Down
Channel
Selection
