MANUAL DE USUARIO
– PROCAM HD II
Página
10
de
44
INMANUUML043 USER M.M. USO PROCAM HD II V.2023.07 ENGESP US
3.4.2.2 VI360 R03 OR LATER
1.
Photo Button
2.
Zoom Button
3.
Brightness Button
4. INSTALLATION
The connection and revision of the equipment must be carried out by technical personnel
with knowledge of the electrical installation from where the equipment will be powered.
1.
Carefully unpack the equipment.
2.
Place the PROCAM HD console on a solid surface.
3.
If the building structure has equipotential grounding, connect the equipment to ground through
the equipotential ground terminal located on the rear panel of the unit.
4.
Connect the connector of the video camera ECLERIS to the connector in the front panel.
5.
Plug the video output connector on the rear panel of the PROCAM HD console to the video
input of the video monitor.
Note:
PROCAM HD supports all the video outputs to multiple devices simultaneously.
Check if the image device (videomonitor / video printer
/ LCD TV / …) supports the camera
resolutions (1080p @ 60Hz / 1920x1080 @ 60 fps).
6.
Connect the optical device with C screw to the camera.
7.
With the equipment off, connect power cable to the electrical socket.
4.1 REVISION
Once the installation is complete and before turning on the PROCAM HD camera we recommend to
do the following controls:
•
Verify that the electrical circuit is connected to ground and in perfect condition and that the
connection to the equipment is done perfectly too.
•
Confirm that the power supply fuses are in the socket and that it is suitable.
•
Make sure no water or liquid supplies, or gases or inflammable fumes in the environment are
near the equipment that can harm it.
•
The equipment has to be connected to the electrical socket through the power cable supplied
by ECLERIS.
•
The electrical supply has to be done at electrical socket without power adapters.
The equipment must be used only in places where the electrical installation complies with
local regulations.
