12
RS-232 COMMANDS
The following table lists all the commands available for the VEO-XWT44E.
Note:
•
Command ending:
“<CR><LF>”.
•
Feedback Error: “COMMAND ERROR” or “OUT OF RANGE”.
•
In the table, “[”and “]” are symbols for easy reading and do not need to be typed
in the command.
•
Type the command carefully, it is case-sensitive.
10.1. Device Control
Command
Description
Feedback Example
#GET_FIRMWARE_VERSI
ON
Get firmware version.
@V1.0.0
#FACTORY_RESET
Restore factory default.
@FACTORY_RESET
#REBOOT
System reboot.
@REBOOT
#HELP
Get all command list.
#SET_SIGNAL_DET TMDS
Set signal detecting mode to TMDS. Signal
exist if detecting TMDS.
@SIGNAL_DET_MODE TMDS
#SET_SIGNAL_DET 5V
Set signal detecting mode to 5V. Signal exist if
detecting 5V.
@SIGNAL_DET_MODE 5V
#GET_SIGNAL_DET
Get the signal detecting mode.
@SIGNAL_DET_MODE TMDS
@SIGNAL_DET_MODE 5V
#SET_KEYPAD_LOCK 0
Unlock panel buttons.
@KEYPAD_LOCK 0
#SET_KEYPAD_LOCK 1
Lock panel buttons.
@KEYPAD_LOCK 1
#GET_KKEYPAD_LOCK
Get panel buttons locking status.
@KEYPAD_LOCK 0
@KEYPAD_LOCK 1
#GET_STATUS
Get device status.
