29
1
SW
7.2.3
EVENTS
3 events are available: 2 of them are triggered by the GPI ports (by means of external,
potential-free contact closures, which are connected to the GPI ports on the rear panel of
the unit) and the other is triggered by silence detection. Both types of events can be
configured on the Events page. By selecting the tab that corresponds to the event, you can
access its configuration.
Please Note:
bear in mind that, for the events to work correctly, they must be enabled in
the
preset
currently in operation.
Figure 9: GPI event configuration example
1.
Page header
: displays GPI and silence events. When you click on the name, it will
display the configuration for that event.
2.
Information
: displays useful information for configuring the events.
3.
Configuration options
for the selected event.
4.
Save & Apply button
: saves the changes made to the GPI that is being edited and
applies them. If the
preset
that is currently in operation has such an event enabled,
it is not necessary to reload the
preset
.
5.
Save button
: saves the changes made to the GPI that is being edited without
applying them. In this way, if the
preset
that is currently in operation has such an
event enabled, the changes will only be applied when the
preset
is reloaded.
6.
Reset button
: resets the changes made to the last saved configuration in the event
that is being edited.
Please Note
: you can configure the different tabs (Source, Target) before saving,
and the changes are retained.
