Ecler ARQISi SB6TiWH, Руководство пользователя

Страница: 11 / 25

11
Note:
The loudspeaker distribution along a 70/100V line historically arises from the
technical requirement to mix loudspeakers of different impedances and/or powers on the
same amplification line or channel, but without any need to worry about the total
impedance of the full assembly. Moreover, this solution enables long cable runs with
significantly smaller sections that those usually employed in low-impedance
installations, but with minimum power losses.
WARNING!
If the system is accidentally connected with the switch in the 100 V/60 W
position to a low-impedance amplifier, no damage will be caused to the loudspeaker, but
its performance will be well below its specifications.
If the loudspeaker is accidentally
connected to a 70 V/100 V network, in the 8 Ω position, it will be seriously damaged.
EQ SETTINGS
Download the Ecler Loudspeakers EQ Settings file for ARQIS105i, ARQIS106i,
ARQIS108i, ARQIS110i, ARQIS112i, ARQIS205i and ARQIS208i, ready to import in
EclerNet Manager software.
RECOMMENDED AMPLIFIER
Following table shows the output power of the amplifier adequate to each acoustic
system:
•
ARQIS105i: 140W RMS
• ARQIS106i: 240W RMS
• ARQIS108i: 300W RMS
• ARQIS205i: 280W RMS
• ARQIS208i: 600W RMS
• ARQIS110i: 600W RMS
• ARQIS112i: 1000W RMS
• ARQISSB6Ti: 240WRMS @ 8Ω
•
ARQISSB10i: 300W RMS
•
ARQISSB12i: 600W RMS
• ARQISSB15i: 1200W RMS