ECKELMANN WRG 3010 E, Инструкция по эксплуатации, Страница: 57 / 113

Firmware V1.4 20.05.2021 57/113
6.3.2 Setting the CAN Bus Address Using Decade Switch S2
Connection to the CAN bus
The connection to the CAN bus is made via terminals 1..4 installed on the left side:
Setting the CAN bus address (node No.) or deactivating CAN bus communication
The decade switch S2 specifies the CAN bus address.
Decade switch S2 Switch positions CAN bus address
/ node No.
(Kn.nnn) Function
1..4
122..125 Assign CAN bus address to controller
0, 5..9 NONE
CAN bus interface deactivated (inactive,
disabled)
The controller is not detected as a CAN
bus device!
For more details on the pin assignment, see chapter Terminal Assignment of CAN Bus .
•
•
ATTENTION
After changing the switch position of S2, the controller must be disconnected from the power
supply for a short time so that the new settings will be adopted!
In installations with
only one WRG 3010 E, the CAN bus address must be set to position 1
(address 122)!
