ECKELMANN WRG 3010 E, Инструкция по эксплуатации, Страница: 12 / 113

Firmware V1.4 20.05.2021 12/113
3 System Design of WRG 3010 E
Basic module WRG 3010 E
The basic module of the controller for heat recovery in transcritical CO
2
systems consists of a digital input/
output module (board above) and an analogue module (board below). An overview of the individual tasks of the
functional units involved in the controller for heat recovery is given in the chapter
Application of WRG 3010 E .
The interfaces for communication are located on the left side, for details see chapter Connections .
The controller is modularly built and can be expanded with a SIOX extension module; see chapter Connection
of the SIOX modules to the controller .
SIOX extension module
The controller can only be operated and parametrised with the PC software LDSWin .
•
•
•
Requirement: In order to use the full range of functions of the WRG 3010 E, one of the following
interconnection controllers must be connected to the CAN bus:
VS 3010 CT (from version 5.34)
VS 3015 CT
VPC 5000
Practical tip: For configuration of the interconnection controller, its operating instructions must be
consulted.
