ECKELMANN VS 3015 CT, Инструкция по эксплуатации, Страница: 149 / 219

Firmware V1.41 V1 08.11.2022 149/219
Connection : Only on the basic module - terminal blocks bottom centre - 4 analogue outputs
Terminal No. Function (0..10 V)
No. Basic module
1
53
54
FC-LT-Compressor
GND
+0..10 V
2
55
56
FC-NT-Compressor
GND
+0..10 V
3
57
58
High pressure valve (HPV) control
GND
+0..10 V
4
63
64
Medium pressure valve (MPV) control
GND
+0..10 V
7.2.6 Connector Pin Assignment for CAN-Bus, SIOX and Interfaces
isolated from other system components (e.g. pressure transmitter). Furthermore this will destroy the
controller!
ATTENTION
Malfunctions due to interference sources! All supply lines from and to the controller (with the
exception of the 230 V power supply and signal cables) must be shielded (cable type: LiYCY)! This
particularly applies for the analogue inputs and outputs (e.g. sensor supply cables) as well as the CAN
bus cabling (see
Basics and General Safety and Connection Instructions ). As a general rule, care
should be taken to ensure that signal cables and cables carrying mains voltage are routed in separate
cable channels.

More Analogue Outputs are provided by the MR-AO4 Module, see Terminal assignment of the Modbus
analogue module 0..10 V DC

DANGER
Warning of dangerous electrical voltage! Danger of electric shock! BEFORE connecting and
disconnecting, it must be ensured that no voltage is present at all connections of the controller.
