ECKELMANN VS 3015 CT, Инструкция по эксплуатации, Страница: 205 / 219

Firmware V1.41 V1 08.11.2022 205/219
•
•
•
•
•
•
•
MESSAGES POS: XXXXX Description
Delete !
Are you sure ?
No: ESC Yes:
Prompt to confirm deletion of messages
Menu 5-3 Modbus
Modbus POS: XXXXX Description
1 configuration Continue to menu 5-3-1
2 diagnostic Continue to menu 5-3-2
3 Rel.Modul.Diag. Continue to menu 5-3-3
4 ebm Diagnose Continue to menu 5-3-4
Menu 5-3-1 Modbus configuration
MODBUS Pos: XXXXXX Description Input
parity Configuration of the parity for the Modbus-Communication → continue to screen 5-3-1-a
baudrate Configuration of the baudrate for the Modbus-
Communication → continue to screen 5-3-1-b
Screen 5-3-1-a Modbus parity
MODBUS POS:XXXXX Description Input Default
even parity is even √ √
odd parity is odd
none no parity configured
Screen 5-3-1-b Modbus baudrate
MODBUS POS:XXXXX Description Input Default Dim.
9600 baudrate is 9600 √ Bd
19200 baudrate is 19200 √ Bd
Menu 5-3-2 Modbus diagnostic is not described here.
Menu 5-3-3 Rel. Modul.Diag. - for diagnosis of the connection of Modbus modules
DIAGNOSE
POS:XXXXX Description Input Default
Address Configuration for which Modbus module the diagnosis parameters shall be displayed 55..56 55
error counter Will be increased if at least one error occures during a communication cycles
maximum number of errors is 5. If the number of errors exceedes 5 an alarm will be signalled -
timeout Error Counter for timeout -
exception Error Counter for exception -
crc Error Counter for crc-error -
wrong response Error Counter for: response was sent from a wrong Modbus Slave (e.g.: request sent to Slave A,
answer received from Slave B) -
error reset If this parameter is set to "Y", the Error Counters will be reset to 0. Afterwards this parameter will
be set to "N" again.
Y N
Menu 5-3-4 ebm Diagnose - for diagnosis of the Modbus connection to ebm-papst fans