ECKELMANN VS 3015 CT, Инструкция по эксплуатации, Страница: 176 / 219

Firmware V1.41 V1 08.11.2022 176/219
•
Ejectors ID: XXXXX
Ejector G 1 XXX Gas ejector 1 ON / OFF
... Only the actual number of gas ejectors is displayed*
Ejector G 8 XXX Gas ejector 8 ON / OFF
Ejector L 1 XXX Liquid ejector 1 ON / OFF
... Only the actual number of liquid ejectors is displayed*
Ejector L 3 XXX Liquid ejector 3 ON / OFF
*up to 8 gas ejectors and up to 3 liquid ejectors are supported; however, maximum 8 ejectors in total
10.1.4 Menu 3 Setpoints
SETPOINTS ID: XXXXX
1 System configuration Continue to menu 3-1
2 Regulation Continue to menu 3-2
3 Comp. monitor Continue to menu 3-3
4 Refrigerant monitoring Continue to menu 3-4
5 -
6 Base load Continue to menu 3-6
7 Messages Continue to menu 3-7
8 -
9 Cond. mon. Continue to menu 3-9
Menu 3-1 System configuration
CONFIG ID: XXXXX Description Input Default Dim.
Refrigerant R744 Refrigerant R744 (CO
2
) - R744 -
Sensor match → Matching of the pressure transmitters → Screen 3-1-a Sensor
match
No. comps. XX Entry of the number of compressors 1..4/8 3/3 -
Diff.comp. X Unequal compressors (only visible with step control and
Anz.Verd.m.LS = 0)
Y/N N -
No comp multist XX Entry of the number of compressors with capacity stages 0..6 0 -
No.cap.stages XX Entry of the number of capacity stages / compressors 1..3 1 -
Bypass invert. X Bypass stages inverted (if yes, the actuation of the relay
outputs for the compressor capacity stages is inverted) If
applicable, coupling relays can be dispensed with for the
bypass valves) Y/N N -
Mot.cutout C X Enable motor overload cutout YES/NO Y/N N -
Motor protect. X Enable motor overload interlock YES/NO (only visible if
Mot.cutout C is set to Y) Y/N Y -
Oil diff. pr. X Oil pressure difference switch / HP switch compressor
YES/NO Y/N N -
Text Oil/HP-F. → Selection of the message text that will be output in the
case of oil pressure or high pressure fault → Screen 3-1-b