ECKELMANN VS 3015 CT, Инструкция по эксплуатации, Страница: 133 / 219

Firmware V1.41 V1 08.11.2022 133/219
5. Fan replacement
Proceed as follows to replace a defective condenser fan:
a. Enter the Superuser password under "Lock-down" to deactivate the setpoint entry block.
b) In the terminal mode in the screen "Switching Order" (menu 3-2-2-1), make a note of the switching order
number of the fan to be replaced and remove the fan from the node table by entering the digit "0".
c. Scan for the replaced fan in the menu 3-2-2-1 (parameter " Lü.scan Tausch = Y “).
After completion of the scan, the parameter automatically changes from "Y" to "N".
d) The new fan is registered in the fan table with the switching order number "—".
e) Enter the desired switching order number (e.g. 1) for the new fan.
6.6 Battery Replacement
No battery replacement for the controller by the user is envisaged as the battery service life is designed for
greater than 10 years. If the " battery voltage " message is displayed, the controller must be sent to Eckelmann
AG to guarantee correct replacement of the battery. Opening the device is not authorised, see chapter VS 3015
CT Installation and Start-Up !
Replacement of the battery after expiry of the warranty is subject to a charge.

ATTENTION
The device contains a lithium battery (for details,
see chapter
Disposal ) that must be
disposed of separately!
Never dispose of this product with other domestic
waste. Please inform yourself about the local
regulations for the separated disposal of electrical
and electronic products and batteries. The correct
disposal of your old equipment protects the
environment and people against possible
negative consequences.

correctly