ECKELMANN VS 3015 CT, Инструкция по эксплуатации, Страница: 121 / 219

Firmware V1.41 V1 08.11.2022 121/219
6.2.4 Settings for RS485/TTY Interface via Jumper J1
Setting of the interface
The jumper J1 specifies the function of the interface.
Jumper J1 Jumper position Interface Function
Left RS485 active
(terminals 13/14/15/16) Factory setting
Right TTY active
(terminals 9/10/11/12) currently has no function
For details, see chapter Connector Pin Assignment for CAN-Bus, SIOX and Interfaces
6.2.5 Setting of the interface of the internal SIOX using jumper J2
The jumper J2 specifies the function of the interface.
Jumper J2 Jumper position Interface Function
Left Communication to the
internal SIOX Factory setting
6.2.6 Factory Setting of Analogue In- and Outputs
The analogue inputs and outputs are configured as follows at the factory:
Analogue inputs 1..5 and 7 4..20 mA
Analogue input 6 0..10 V
Analogue outputs 1..4 0..10 V
ATTENTION
Reconfiguration of the interface for the internal SIOX is only required if settings other than those in the
delivery condition are required. A reconfiguration or any opening of the controller must only be
performed by trained personnel or at the factory by the manufacturer. Incorrect handling can result in
damage and impairment of the controller functions!

ATTENTION
Important safety information! Any maintenance by the user is not intended as possible hazards from
incorrect re-assembly cannot be ruled out. Opening the device is not authorised! Reconfiguration of
the analogue inputs and outputs is not necessary. Incorrect handling can result in damage and
impairment of the controller functions!
