ECKELMANN VS 3015 C, Инструкция по эксплуатации

Страница: 91 / 185

14.01.2019 91/185
S2 decade switch Switch position CAN bus address
/ node number
(Kn.nnn)
Function
0 NONE CAN bus communication of the pack controller disabled
1..9 101..109 Node number nnn is assigned to the pack controller
Connection to the CAN bus
The connection to the CAN bus is made using the terminals 1-4 installed on the left side, see chapter Belegung
CAN-Bus, SIOX und Modbus (ebmpapst-Lüfter) .
1
2
3
4
SHIELD
GROUND - green
CAN-LOW - brown
CAN-HIGH - white
6.3.4 Setting of the interface RS485/TTY using jumper J1
Setting of the interface
The jumper J1 specifies the function of the interface.
Jumper J1 Jumper position Interface Function
Left RS485 active
(terminals 13/14/15/16)
Factory setting,
currently has no function
Right TTY active
(terminals 9/10/11/12)
currently has no function
For details, see chapter Belegung CAN-Bus, SIOX und Modbus (ebmpapst-Lüfter) .
After changing the switch positions of both S1 and S2, the controller must be disconnected from the
power supply for a short time so that the new settings will be adopted!
