KGL Operating Manual – VS 3010 BS
2018-07-02
/
167 178
HISTORY ID: XXXXX
Input
Date: dd/mm/yy
Date
Act. Z2 daytime XXX %
↓
Activity Z2 daytime in %
Selection max. 31 days in the past using ↑↓
↓, ↑, ESC
Menu 6-5-9 Activity Z2 night
HISTORY ID: XXXXX
Input
Date: dd/mm/yy
Date
Act. Z2 night XXX %
↓
Activity Z2 night in %
Selection max. 31 days in the past using ↑↓
↓, ↑, ESC
9.1.8 Menu 7 Default settings
All parameters of the pack controller are reset to the factory settings. The following screen is displayed:
VS3010BS ID: XXXXX
Load default settings?
Are you sure?
NO: ESC YES:
Confirmation prompt for loading the default parameters
Warning about system damage! The default settings should not be loaded as the controller will be
reset to values that usually have nothing to do with the real system configuration!
After loading the default settings, the system-specific configuration of the pack controller
be
must
performed!
9.1.9 Menu 8 Service Mode
SERVICE ID: XXXXX
1 Analogue values
Continue to menu 8-1
2 Compressors Z1
Continue to menu 8-2
3 Compressors Z2
Continue to menu 8-3
4 Fans
Continue to menu 8-4
5 System
Continue to menu 8-5
6 D2D
Continue to menu 8-6
Menu 8-1 Default analogue values
SERVICE ID: XXXXX
Input
Default
Dim.
AnalogOut1 X.X V
Voltage at the analogue output 1 (terminals 53, 54)
0.0..10.0
0.0
V
AnalogOut2 X.X V
Voltage at the analogue output 2 (terminals 55, 56)
0.0..10.0
0.0
V
AnalogOut3 X.XX V
Voltage at the analogue output 3 (terminals 57, 58)
0.0..10.0
0.0
V
AnalogOut4 X.XX V
Voltage at the analogue output 4 (terminals 63, 64)
0.0..10.0
0.0
V
Menu 8-2 Compressor Z1 defaults ON/OFF
