Introduction Manual ENC66
eckelmann.de
In the terminal program it looks like this:
Abbildung 9:
Figure 9:
Select the correct interface
The next prompting refers to the serial interface to which the connection cable is connect-
ed to the controller (e.g. COM1). Input the following values as interface parameters:
Tabelle 15:
Table 15:
connection parameters
Parameter
Value
Baudrate
115200 Baud
Number of Data bits
8
Parity
no
Stop bits
1
Flow control
no
The dialog box looks like this:
Abbildung 10:
Figure 10:
Dialog box with connection parameters
After the parameterization the terminal window opens as follows:
Содержание E-Control CNC
Страница 92: ...92 97 Abbildung 66 Figure 66 Controller error message in the StdHMI ...
Страница 96: ...96 97 ...
