ECKELMANN Compact GLT 3010, Инструкция по эксплуатации

Страница: 21 / 119

Firmware: V2.18 / V-- 26.10.2022 21/119
•
•
5.2 Starting Characteristics
The following are distinguished for any start-up of the controller:
First start
Restart
5.2.1 First Start
A first start is triggered when the (new) CODESYS application is started for the first time. This is independent
from the start of the controller.
During a first start, the parameters and setpoints are set to the default values defined by the programmer if the
setpoint check function block has been programmed accordingly.
The programmer of the application determines whether and when a first start is triggered when the application
is changed and started for the first time.
5.2.2 Restart
The restart takes place after restoration (switching on) of the supply voltage . If programmed accordingly, the
parameters and setpoints are read from the EEPROM via the setpoint check function block.
5.3 Controller configuration
The controller configuration is used to establish the link between the inputs and outputs and the application,
and their parametrisation. It is located in the "Resources" tab in the development system:
ATTENTION
Before loading a new/changed application with an expected first start, the data can be backed up
previously using the LDSWin PC software. This function is available in LDSWin under the menu item
"Store=> Print setpoints => GLT setpoint channels".
