Firmware V6.6.9
29.07.2020
26/147
The two relay outputs can be used, for example, to control a telephone dialling device. If an alarm with the
priority X1 or X2 is generated by any of the E*LDS components, the assigned relay output of the corresponding
priority is activated.
If the output was already active, this is deactivated for approx. 5 seconds and then activated again (changed
last-in alarming) if at least 5 minutes have elapsed since the last activation of the alarm output.
If 2 or more alarms occur within this wait time, the changed last-in alarming is postponed until the wait time has
elapsed. The respective alarm outputs are automatically deactivated again when e.g. after pressing the Horn
button (see chapter
), no alarms with the corresponding priority are contained
in the alarm list.
The alarm outputs are self-holding with time-delayed automatic alarm signalling in the event of power failure.
The current states of the outputs are maintained if the mains voltage of the controller is switched off for a short
time. If the controller remains switched off for longer than approx. 5 minutes (absence of voltage), both relay
outputs switch to the alarm state.
5.5.2 Multi-function relay AUX
Configuration
In addition to the prioritised
ones, the controller also has the changeover contact
AUX (terminals 15/16/18, see chapter
Terminal assignment of the 230 V AC relay outputs
).
The relay output can be configured via Menu 4-1-7 (Other) with any of the following parameters for these
functionalities:
Содержание CI 4000 Series
Страница 143: ...Firmware V6 6 9 29 07 2020 143 147 ...
