H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
23
1. Before adjusting the carburetor, clean or replace the air filter and
spark arrester screen.
2. Start engine and run for several minutes to reach operating tempera-
ture.
3. Stop engine. Turn HI (A) speed needle CCW (counter clockwise) to
stop. Turn LO (B) speed needle midway between full CCW and CW
(clockwise) stops.
4. Idle Speed Adjustment.
-Start engine and turn idle (C) speed adjustment screw CW until the
blades begin to move, then turn the screw CCW until blades stop
moving. Turn screw CCW an additional 1/4 turn.
5. Accelerate to full throttle for 2-3 seconds to clear excess fuel from
engine then return to idle. Accelerate to full throttle to check for
smooth transition from idle to full throttle. If engine hesitates, turn
LO (B) needle CCW an additional 1/8 turn and repeat acceleration.
Continue adjusting until smooth acceleration results.
6. Check HI speed RPM at W.O.T. (Wide Open Throttle). HI speed
RPM should be set to specifications found on page 12 "Specifica-
tions" of this manual.
7. Check idle speed and reset if necessary. If a tachometer is available,
idle speed should be set to the specifications found on page 12
"Specifications" of this manual.
WARNING
DANGER
When carburetor adjustment is completed, blades should not move
at idle, otherwise serious personal injury may result.
C
B
C
A
CARBURETOR
ADJUSTMENT
Emission Models
Level 2.
Tools required: Screwdriver with 2mm blade width, Tachometer
(ECHO P/N 99051130017)
Parts required: None.
NOTE
Every unit is run at the factory and the carburetor is set in compliance with EPA Phase 1 and California Emission
Regulations. In addition, the carburetor is equipped with HI (A) and LO (B) needle adjustment limiters that prevent
settings outside acceptable limits.
