H
EDGE
C
LIPPER
O
PERATOR
'
S
M
ANUAL
17
4. START - PULL ROPE
Lay the hedge clipper on a flat clear area and pull the recoil starter
handle (D) until engine fires.
5. OPEN CHOKE - RUN.
Move choke (B) to the RUN (OPEN) position. Restart engine if
necessary and allow unit to warm up at idle for several minutes.
WARNING
DANGER
The blades should not move at idle. If blades move, readjust
carburetor according to "Carburetor Adjustment" instructions in
this manual or see your ECHO Dealer, otherwise serious personal
injury may result.
6. After engine warm up, gradually depress throttle trigger to increase
engine RPM to operating speed.
STARTING
WARM
ENGINE
The starting procedure is the same as Cold Start except DO NOT close
the choke.
WARNING
DANGER
The blades should not move at idle. If blades move, readjust
carburetor according to "Carburetor Adjustment" instructions in
this manual or see your ECHO Dealer, otherwise serious personal
injury may result.
1. STOP SWITCH - START/RUN
Move stop switch (A) away from the STOP position.
2. START - Pull Rope
Lay the hedge clipper on a flat clear area and pull the recoil starter
handle (D) until the engine fires.
NOTE
If engine does not start after 5 pulls, use Cold Start Procedure.
B
COLD
START
RUN
IDLE
H L
