C
HARGING
S
TATION
I
NSTALLATION
P
ROCEDURE
S
ECURING
THE
B
ASE
7
3)
Remove 0.4 in. (11 mm) of insulation from the
end of each wire.
4)
Install each wire into its corresponding large
terminal block opening.
5)
Insert a flat
‐
blade screwdriver into the small
opening of the terminal block directly behind the
wire and pry the spring contact open. Only install
one wire per terminal block opening. The
stripped ends of the wire (or stray strands of
wire) must remain on the inside of the terminal
block.
6)
Remove the screwdriver. Firmly pull each wire to
verify a secure connection.
Securing the Base
Mower application only:
Remove underground haz
‐
ards below the charging station. Use a hammer to
install the four landscaping spikes to secure the base to
the ground.
Range Picker application only:
Use the appropriate
size and type of fastener to secure the charging station
to the foundation of the ball collection system.
1 – Small terminal block openings
2 – Large terminal block openings
1
2
