M
AINTENANCE
P
ROCEDURES
C
OLD
W
EATHER
S
TORAGE
(
AS
INSTALLED
)
9
Maintenance
Procedures
During periods of wet weather, perform inspection and
cleaning once per day.
1)
Move the power switch to the OFF position.
2)
Turn off AC power at the mains (charging station
only).
3)
Remove robot from charging station (if
required).
4)
Visually inspect the unit, replace damaged
components.
5)
Check all electrical connectors, reconnect if
necessary.
6)
Use a plastic scraper, nylon brush, compressed
air, or a damp cloth to clean dirt, grass, sticks, or
obstructions.
NOTE: Do not use a high
‐
pressure washer or running
water for cleaning.
Never use solvents.
Cold Weather Storage
(as installed)
1)
Move the power switch to the OFF position.
2)
Turn off AC power at the mains.
3)
Cover the charging station with a non
‐
conduc
‐
tive, waterproof barrier.
Cold Weather Storage or Moving
(removed from installation)
1)
Move the power switch to the OFF position.
2)
Turn off AC power at the mains.
3)
Remove the M5 nuts (8X) from the base of the
enclosure top. Save the nuts for reassembly.
4)
Remove the AC wires (neutral
‐
white, line
‐
black,
ground
‐
green) from the terminal block.
5)
Loosen the conduit connector lock nut (located
on inside of input panel). Pull conduit, connector,
and AC wires out of the input panel.
1 – Lock nut
2 – Input panel
3 – Conduit, connector, AC wires
3
1
2
2
1
