Ebyte ME31-XAXX0600, Руководство пользователя

Страница: 21 / 30

Chengdu Ebyte Electronic Technology Co.,Ltd ME31-XAXX0600_UserManual_CN
Copyright ©2012–2023
，
Chengdu Ebyte Electronic Technology Co.,Ltd
18
4.5.2 Device parameter display interface
Press the left or right button to enter the password input interface, complete the correct password input, and
display the device parameter information interface (password interface: default password: 0000; short press the
middle verification password, left and right buttons to switch password bits, up and down buttons to switch current
bit values, a total of 4 digits of the password, with each input range of 0-9 digits):
The parameter setting interface from top to bottom is
1. :Modbus address;
2. Baud rate;
3. Data bits;
4. Check digit;
5. Stop bit;
6. Local port
7. Local IP address
8. Network mode
9. Gateway
10. Subnet mask
11. DNS
12. MAC address
13. DHCP
14. Target IP
15. Target port
16. Modbus TCP/RTU protocol conversion
17. Active upload
18. Modbus address filtering
4.5.3 Device parameter configuration interface
Long press the confirm button to enter the password input interface, complete the correct password input, and
enter the configuration interface (password interface: default password: 0000; short press the middle to verify the
password, left and right buttons to switch password bits, up and down buttons to switch current bit values, a total of
4 digits of password, with each digit entering a range of 0-9 numbers).
Select the setting option, enter the parameter configuration page, and briefly press the up and down keys to
switch between the setting options;
Select the setting item, short press to confirm or right-click, and the cursor for the setting item represents the
selected item and enters the setting item;
Adjust parameter values: After selecting the setting option, the up and down keys can change the numerical
value or optional values; Press the left and right buttons to move the cursor within the parameter item;
Confirm parameter values: After adjusting the parameter values, press the confirm button to exit the current
setting.
Save parameter settings and restart: After setting the parameters, move the cursor to save and restart, then
short press the confirm button to enter the confirm save and restart state. Short press the confirm button (press other
buttons to exit the confirmation state) to save the parameters and restart the device.