Ebyte E96-DTU, Руководство пользователя

Страница: 17 / 22

Chengdu Ebyte Electronic Technology Co.,Ltd. E96-DTU(400SL30-485) User Manual
Copyright ©2012–2021
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
16
Cycle T= (1+WOR)*500ms, the
maximum is 4000ms, the minimum is
500ms;
The longer the WOR monitoring interval
period, the lower the average power
consumption, but the greater the data
delay;
Both sender and receiver must agree
(very important)
0 0 0 500ms
0 0 1 1000ms
0 1 0 1500ms
0 1 1 2000ms
1 0 0 2500ms
1 0 1 3000ms
1 1 0 3500ms
1 1 1
4000ms
07H Write CRYPT
_H
High byte of key (default 0) Only write, read returns 0;
Used for encryption to avoid interception
of wireless data in the air by similar
radio stations;
The radio station will use these two bytes
as a calculation factor to transform and
encrypt the wireless signal in the air.
08H Write CRYPT
_L
Low byte of key (default 0)
80H
～
86H
Read PID
Product information 7 bytes
Product information 7 bytes
7.3 Factory Default Parameters
Product model
Factory default parameter value:C0 00 00 62 00 00
Radio model Frequency Address Channel Air rate Baud rate
Serial
format
Transmit
power
E96-DTU(400SL22-485
)
433.125M
Hz
0x0000 0x17 2.4kbps 9600 8N1
30dBm (small
power)
8 Relay Networking Mode Use
Serial number Relay mode description
1
After setting the relay mode through the configuration mode, switch to the normal mode, and the
relay starts to work.
2
In the relay mode, ADDH and ADDL are no longer used as the radio address, but correspond to
the NETID forwarding pairing respectively. If one of the networks is received, it will be
forwarded to the other network. The network ID of the repeater itself is invalid.
3
In the relay mode, the relay station cannot send and receive data, and cannot perform low-power
operation.
4
When the user enters other modes from Mode 3 (sleep mode) or is in the reset process, the radio
will reset the user parameters, during which AUX outputs low level.
Description of relay networking rules: