Chengdu Ebyte Electronic Technology Co., Ltd.
E22-xxxT22S series product user manual
Copyright©2012–2024
, Chengdu Ebyte Electronic Technology Co., Ltd.
26
ADDH\ADDL of Repeater 1 are 08
，
33 respectively.
So the data sent by node 1 (08) can be forwarded to node 2 (33)
Meanwhile,node 1 and node 2 have the same address, so the data transmitted by node 1 can be received by node 2.
②
Secondary repeater
ADDH\ADDL of Repeater 2 are 33
，
05 respectively.
Therefore, Repeater 2 can forward the data of Repeater 1 to the network NETID: 05.
Thus node 3 and node 4 can receive the data from node . Node 4 outputs data normally, but no ourput from Node3 because Node 3 has
a different address from Node 1.
③
Two-way repeater
As shown in below
：
The data sent by Node 1 can be received by Node 2 and Node 4;
The data sent by by Node 2 and Node 4 can also be received by Node 1.
10. Configuration instructions on computer
The following figure is the display interface of E22-900T30D configuration on computer. User can switch to the command mode
through M0, M1, and quickly configure and read the parameters on computer.
