Chengdu Ebyte Electronic Technology Co., Ltd.
E22-400T22S1C User manual
Copyright ©2012–2018，Chengdu Ebyte Electronic Technology Co.,Ltd.
18
101：3000ms
110：3500ms
111：4000ms
07H
Write
CRYPT_H
Key high byte (default 0）
Write only, read returns 0
Used for user encryption to avoid intercepting
airborne wireless data by similar modules.
The module will internally use these two bytes as
a calculation factor to transform and encrypt the
over-the-air wireless signal.
08H
Write
CRYPT_L
Key low byte (default 0)
80H~
86H
Read
only
PID
Product information 7 bytes
Product information 7 bytes
7.3 Factory default parameter
Factory default parameters：
C0 00 00 62 00 17
Model No.
Frequency
Address
Channel
Air data rate
Baud rate
Parity format
Power
E22-400T22S1C
433MHz
0x0000
0x17
2.4kbps
9600
8N1
22dbm
8 Repeater networking mode
No.
Description
1
After setting the repeater mode by configuration, switch to the normal mode and the repeater starts working.
2
In the repeater mode, ADDH, ADDL are no longer used as the module address, but is correspondingly paired with the
NETID. If the data of one of the networks is received, it is forwarded to another network. The network ID of the repeater
itself is invalid.
3
In repeater mode, the repeater module cannot transmit and receive data, and cannot perform low-power operation.
4
The user enters the other mode from mode 3 (sleep mode) or during the reset process, the module resets the user
parameters during which the AUX outputs low level.
Repeater networking rules:
1. Forwarding rules, the repeater can forward data in both directions between two NETIDs.
2. In repeater mode, ADDH\ADDL is no longer used as the module address, and it is used as a NETID forwarding pairing flag.
Figure:
1
Primary repeater
“Node 1” NETID is 08.
“Node 2” NETID is 33.
Primary repeater 1‘s ’ADDH\ADDL are 08，33.
