Ebyte E180-ZGI20B-TB, Руководство пользователя

Страница: 4 / 5

Chengdu Ebyte Electronic Technology Co., Ltd. E180-ZG120B-TB User Manual
Copyright ©2012–2019 ， Chengdu Ebyte Electronic Technology Co., Ltd. 3
Description
：
No. Pin Description
1 AVDD Module power port, 3.3V power
supply is recommended
2 3.3V Baseboard LDO output 3.3V, can
supply power to the module
3 TXD TXD of cp2102
4 RXD RXD of cp2102
5 PA1 RXD of the module
6 PA0 TXD of the module
No. Name Direction Function
1 GND - Ground, connected to power supply reference ground
2 GND - Ground, connected to power supply reference ground
3 PD13 Input
TOUCHLINK pin, which is continuously pulled lower than 3000ms,
will initiate a ZLL network establishment or join request
4 PD14 Input
WAKE pin is mainly used to wake up the sleep terminal. It is high level
when powered on. When the pin is pulled low externally, the sleep
terminal device will be woken
5 PA0(TX) Output Serial port transmission port TX
6 PA1(RX) Input Serial port receiving port RX
7 PA2
Input/Outp
ut
Reserve
8 PA4
Input/Outp
ut
Reserve
9 PB11 Input
Operating mode switching pin. When the pull-low time is longer than
500ms, the operating mode is switched.
10 PB12 Input
UART_BAUD_RESET pin is used to reset the device baud rate. The
power-on default is high level. In any mode, if this pin is pulled lower
for more than 1000ms, the serial port parameters of the module will be
restored to the default 115200.
11 PB13 Output
ACK pin is used to indicate the last user data transmission status. This
pin is pulled low before the transmission is started, and the pin is pulled
high after the transmission.
12 PB14(GPIO0)
Input/Outp
ut
GPIO Input/ Output port 0
13 3.3V - Module power supply positive reference voltage, voltage range
14 GND - Ground, connected to power supply reference ground