Chengdu Ebyte Electronic Technology Co.,Ltd.
E104-BT12LSP User Manual
Copyright ©2012–2021
，
Chengdu Ebyte Electronic Technology Co.,Ltd.
21
5.1 Use of switches
When E104-BT12 is networked, you need to group the address of the element under the current device.
When I have three devices: A and B and C, use danglog to network them all. Note that all devices that are not low power
nodes are automatically grouped to C000. It is best to remove C000 when you verify switch function.
Then B device element is then assigned to C002 and C device to C003.
If the two switches DIO1 through device A are connected high, then device B lights up, DIO.If one is low, then device B
lights go out.
Switch DIO2 to low C device lights out, DIO2 to high, C device lights on.
6. Quick get start
This chapter introduces how E104-BT12SPs form networks quickly and how to control network message transmission
and delivery.
6.1 Restore factory settings restore
Send the following instruction 02 C006 and you'll receive a return 0343 0600, E104-BT12NSP in the same format as the
E104-BT12LSP instruction.
Baud rate:115200, other8N1, do not return to change lanes.
