PX200NB
–
Manual
Page 30 / 57
7.4.2.3.
Event control
Note: Do not use the basic output configuration and the advanced output
control at the same time!
In the “Event control” you may define separately the behavior of each of the outputs,
depending on events taking place. “Advanced outputs control” differs from the existin
g
basic “Outputs configuration” by:
o
making it possible to not only to turn on but also to turn off the output
o
output can be activated temporarily for specified amount of time
o
there is a complete list of events for which you can define the behavior of the
output.
Note: Do not use the basic configuration of outputs and the
“Advanced
outputs control”
at the same time!
In particular, the basic configuration of existing options:
“No GSM signal (immediately
after detection)” and “
Dependent on state transitions from non-active to active of one
of the inputs
” should not be used with their replacements “[Off] GSM” and “[On] Input
x”. The use the basic configuration of outputs and “Advanced outputs control” at the
same time, may cause unexpected behavior of the communicator.
Advanced Event Types:
•
Inputs (on/off, lock, tamper);
•
Power (power and battery failure);
•
Partitions (arming/disarming);
•
Telephone line (call initiation/termination, picking up/putting down the
handset, dialing);
•
Transmitter status (service);
•
Communication with monitoring center (jamming, data transmission control,
configuration change, time setting);
•
Informational (Clip, start of transmitter - communicator);