124
EN
EBS Ink Jet Systeme
20150330#1.0
EN
If the printer remains idle for a longer period (over 3 weeks), ink may
partially dry in printer components. Therefore follow the storage instructions
given below:
if the printer has already been used before, store it with ink container
protect the printer against dust, dirt, any influence of aggressive vapors
and gases and excessive temperature and moisture. Ideally, place the
printer in a polyethylene tight bag, remove air from the bag and close it
tightly. Then place it in the packing case.
The printer should be stored and transported in the packing case delivered
with the printer. During normal operation avoid exposing the printer to
strong mechanical shocks (protect the printer, especially nozzles
, keypad
hard surfaces or scratching with sharp objects).
User Support
Problems with Functioning and Operation of the Printer
Some of the nozzles do not jet ink
Some drops are missing on a print.
or
Aim the nozzle outlet at a vessel, for example the one you use to wash the
printer.
Wash the nozzles with wash-up, if they are covered with dried ink.
Start the purging function
).
When ink is jetted out of every nozzle regularly, release trigger
!
Frequent and long-lasting use of the purge function increases ink
consumption.
The printer does not print
On initiating printing and making an attempt to print you can hear the
electromagnets of the nozzle valves operating but ink drops are not always
jetted out of the nozzles properly. The quality of printing deteriorates or no print
is produced.
This may occur when the ink filter is choked. After about 50 ink containers (or
over 10 liters of ink) have been consumed, however not less frequently than
every four years, the built-in ink filter should be checked and replaced, if need
be. It is recommended that the replacement operation be performed by qualified
or EBS service staff.
Boldfaced or Blurred Prints
The print is heavily saturated with ink, ink drops blur and the entire print seems
to spread over the object being labeled.
