EPX400-A20CU – Manual
Page 11 / 62
WARNING:
The wiring should be done only when the control panel and the
communicator are disconnected from the power supply.
The internal antenna used with communicator must be installed to provide separation
distance of at least 7.8 in (20cm) from all persons and must not be co-located or
operating in conjunction with any other antenna or communicator.
3.4.
INPUT CONFIGURATION
Inputs IN1 – IN9 might work as normally closed (NC) or normally open (NO).
Additionally inputs might be configured as end of line (EOL-NO or EOL-NC) with
resistors 2.2kΩ or as double end of line (DEOL-NO or DEOL-NC) with resistor 1.1kΩ.
Examples of connecting sensors to the inputs in various configurations are shown in
figure 2.
Figure 4. Configuration of input lines
