AVA PRO - Assembly instructions for the CPX300W alarm control panel
12
/
23
- Connector for installation of the module,
- Mounting hole for the screw,
- Ethernet connection for connecting the network,
Fig. 5. View of ETHERNET module boards with descriptions.
3.3.2.
Module installation
The module should be inserted at an angle of approximately 30° (to minimize the possibility of damage
to the connector) into the dedicated connector on the CPX300W motherboard (labelled "ETH / Wi-Fi" -
see Fig. 1, item 9) and then screwed with a screw attached to the set (Fig. 5, item 2).
NOTE! All installation activities should be carried out with power disconnected.
3.3.3.
Technical parameters of the Ethernet module
Table 3. Technical parameters of the Ethernet module.
Supported connection standards
10Base-T | 100Base-TX | Auto MDI/MDI-X
Ethernet connector
RJ45, shielded
Dimensions
36.5 mm x 27 mm
3.4.
WiFi
3.4.1.
Description
WLAN wireless communication module cooperating with the CPX300W alarm control panel, powered
directly from the control panel motherboard. The module enables connecting the CPX300W control
panel to a wireless WLAN network (WiFi network available at the place of installation).
- Connector for installation of the module,
- WPS button,
- SMD antenna,
- Mounting hole for the screw.
Fig. 6. View of the module boards with descriptions.
3.4.2.
Module installation
The module should be inserted at an angle of approximately 30° (to minimize the possibility of damage
to the connector) into the dedicated connector on the CPX300W motherboard (labelled "ETH / Wi-Fi"-
