EBS Ink-Jet Systems EBS-6200, Руководство пользователя, Страница: 74 / 124

EBS-6200
Printer User's Manual
Chapter 4 - Operating the Printer
72
200
4.4.6.
General Information
ottle of ink or solvent is equipped with
ra bottle
nee ntact or additional power supply). The
information is scanned from the transponder with a built-
n breviation IMS will be
e aerials situated at the
and solvent distribution and monitoring are
Ink and Solvent Bottle Monitoring System
Every b
a
t nsponder (an electronic circuit where
identification data is stored and can be accessed with no
d for wire co
A bottle niche in the
in I nk M o itoring S ystem (the ab
used her inafter) that uses two
bottom of the bottle compartment.
The I nk M onitoring S ystem ensures that:
1) The bottle is identified explicitly.
2) The printer is checked for appropriate ink (solvent).
It prevents the application by mistake of ink (solvent)
that is different from that origi
Ink system door
nally used in the
printer’s ink system. The type and service life of the
consumable are checked.
3) Ink
improved as the information is coded and validated
electronically in every transponder.
IMS aerials for
solvent ink
Fig. 4.4.6.1.
bottle can be only used in the printer for which it was accepted by IMS . Approved bottles cannot Each
b nnot be replenished with fluid from an approved bottle.
T a
If IMS messages concerning a specific bottle are displayed on the terminal, they are always preceded
m
e moved to other printers and other bottles ca
he pproved bottle should remain in the printer until the fluid is consumed.
!
by an indication of which bottle they relate to:
•
If IMS essages concerning the ink bottle are displayed in the main window on the terminal
display, they are preceded by the indication “ INK: ”, whereas if they are displayed in the printer
t is “ I: ”. status window, they are preceded by the first letter of the indication, tha
•
If IMS messages concerning the solvent bottle are displayed in the main window on the terminal
display, they are preceded by the indication “ SOLVENT: ”, whereas if they are displayed in the
printer status window, they are preceded by the first letter of the indication, that is “ S: ”. For
example:
Replacing Bottle of Ink (Solvent)
icated with a sound alarm (and possibly a light signal) and
INK:
for t
SOLVENT:
The empty bottle condition is normally ind
the following terminal message:
EMPTY BOTTLE
he bottle of ink
or
EMPTY BOTTLE
for the bottle of solvent.
91020#1.0