Eaton XV400 5.7", Руководство по эксплуатации

Страница: 37 / 78

5 Installation
5.3 Interfaces
MICRO PANEL XV400 5.7"/8.4" 12/2014 MN04802009Z-EN www.eaton.com
37
5.3.8 CAN
The CAN interface is electrically isolated.
Tab. 14 Pin assignment of CAN interface in accordance with CiA
Wiring

Shielded twisted pair cables must be used.
Tab. 15 Cable specifications

The maximum baud rate depends on the cable length:
Abb. 20 CAN interface (9-pin, D-Sub, male, UNC)
Pin Signal Assignment
1 - nc
2 CAN-L Bus line (dominant low)
3 CAN-GND CAN Ground
4 - nc
5 - nc
6 GND Optional CAN Ground
7 CAN-H Bus line (dominant high)
8 - nc
9 - nc


Pin 3 (CAN-GND) and 6 (GND) are connected internally in the device.

nc: Pins 1, 4, 5, 8 and 9 must not be connected.

The CAN bus drivers are fed internally with power.

No power supply for third-party devices is implemented on the CAN connector.
1 2 3 4 5
6 7 8 9
Cable specifications
Rated surge impedance 120

Permissible surge impedance 108…132

Capacitance per unit length < 60 pF/m
Core cross-section / max. cable length

0.25 mm
2
/ 100 m

0.34 mm
2
/ 250 m

0.75 mm
2
/ 500 m