Eaton XV-102 Series, Руководство пользователя

Страница: 41 / 80

5 Installation
5.3 Interfaces
Touch display XV-102 10/2020 MN04802004Z-EN Eaton.com
39
5.3.8.5 Commissioning the SmartWire-DT network
Switching on for initial startup, a replacement or a changed SmartWire-DT configuration
Requirement:

All SmartWire-DT modules must be connected to each other via SmartWire-DT cables.

The SmartWire-DT network must be connected to the SmartWire-DT interface.

The power supply for the device and for SmartWire-DT must be on and connected.

The SmartWire-DT master's POW LED must be lit up with a solid light.

The SmartWire-DT status LEDs of the connected SmartWire-DT modules must be flashing or
showing a solid light.

A PLC project with configured SWD-Master exists (project configuration).

The PLC runtime system must be installed on the device.
Procedure:
1 Press the configuration button «Config» for at least two seconds.

The SWD LED of the SmartWire-DT Master interface begins to flash orange and the Smart-
Wire-DT status LEDs on the connected SmartWire-DT slaves flash.

The SmartWire-DT master interface's SWD LED will start flashing with a green light

All SmartWire-DT modules are addressed.

The SmartWire-DT network's physical configuration will be stored in the device's non-volatile
memory as a target configuration.

The SmartWire-DT master interface's SWD LED will start showing a solid green light.
2 Download the PLC project onto the device.

If the project configuration is identical to the stored target configuration, the Config LED lights
up green and the data exchange of the input and output data can start.