background image

1

91712

S e r v i c e   P u l l o u t  
I n s t a l l a t i o n

Service Pullout

Rev. __         Date: 

TOOLS REQUIRED

(1) 7/16” Socket wrench (not supplied)
(1)   3/8” Socket wrench (not supplied)
(1) 5/32” Allen wrench (supplied)
(1)   Level (not supplied)
(1)   Rubber mallet

IMPORTANT!

The LMS Full Frame 

must be level 

before installing the Service Pullout.

1. Determine the desired height of the Service Pullout 

and then insert the hooks* on the back of the unit into 
the slotted standards and push down.  See figure 2a.  
To ensure that the hooks are seated, tap the top rear 
corners with a rubber mallet.    

The Service Pullout can be installed at four different 
heights at one inch increments.  The minimum height is 
34”, the maximum height is 43”.  See figure 1.

POSITIONING THE SERVICE PULLOUT

Figure 1

43” Maximum

34” Minimum

Service Pullout

LMS Full Frame

ITEM NUMBERS

ALLEPSD2430
ALLEPSD3030
ALPEPSD2430
ALPEPSD3030

*NOTE

:

  

It is suggested that the hooks be bent out 

slightly to ease insertion into the slotted standards.  
See figure 2b. 

Figure 2a

Hooks

Slotted standards

Hook Plates

Figure 2a

Hook

Bend out slightly

Отзывы: