Eaton VORAD AlwaysAlert, Руководство по установке

Страница: 20 / 30

17
Component Installation
Wiring Harness Connection to Vehicle Wiring
Use the Butt connectors provided in this kit to connect the system wires to the existing vehicle wires (see Connector
Wiring).
Parts:
Terminal, P/N 2B-14, Thomas & Betts®
Solder sleeve, P/N CWT-3805, Raychem®
Shrink tubing 5/16
1. Cut the vehicle wire and slide a solder sleeve over the wire that will remain single. Install the solder sleeve so
the blue band is nearest the end just cut.
2. Strip 3/8" of insulation from the end of the wires just cut and the wire to be added.
3. Insert the single wire into one side of the terminal until the wire can be seen at the middle of the terminal.
Crimp the wire in place.
4. Slide a 4" piece of heat-shrink tubing over the two other wires.
5. Insert the two stripped wires into the other end of the terminal. Crimp the wires in place.
6. Slide the solder sleeve over the crimped terminal until the solder ring is centered over the middle of the termi-
nal. Use a heat gun to melt and shrink the solder sleeve over the terminal.
7. Slide and center the shrink tubing over the solder sleeve. Use the heat gun to melt the solder ring and shrink
the tubing.
1 - Shrink tubing
2 - Heat gun
3 - Wires 4 - Solder sleeve
5 - Solder ring
1
3 3 4 4 5
2