38
Transmission appearance may differ, procedure is the same.
Torque Converter
How to Remove the Torque Converter Housing
Special Instructions
Removal of the torque converter housing is done in
the vertical position.
Disconnect the torque converter and harness from
ECU.
Disconnect the hydraulic valve.
Remove the synchronizer system lube line, the sump
return tube, and the dipstick.
Special Tools
Typical service mechanic tools are needed
To Remove
1.
Remove the stator support seal ring.
2.
From the stator support, remove the retaining
capscrews.
3.
Remove the stator support and gasket.
4.
Remove the torque converter housing retaining
capscrews with washers.
5.
Remove the torque converter housing nuts with
washers.
6.
Remove the torque converter housing and gasket
from the transmission case.
7.
Inspect the synchronizer system lube elbow
adaptor, remove if damaged.
8.
Inspect the torque converter housing seal,
remove if damaged.
9.
Remove the magnetic sensor. Inspect the O-ring,
remove if damaged.
10.
Inspect the stator support O-ring, replace if
cracked or distorted. The O-ring is not used on
9109 Models.
11.
Remove all piston rings on the input shaft.
H/52-1
H/26-3
H/26-5
H/27-5
H/25-7
H/26-4
H/27-4
H/27-6
4
5
6
7
8
9
1
2
3
