Transmission appearance may differ, procedure is the same.
13
Auxiliary Section
Output Shaft Assembly
How to Assemble the Output Shaft Assembly
Special Instructions
Make sure the magnetic plugs are installed in the
auxiliary housing.
Output shaft stack up should be done on a clean, flat
surface.
When heating the bearings, do not heat bearings above
275
°
F (136
°
C).
When installing the rear bearing oil seal, press into the
rear bearing cover flush with the machined step. A thin
coat of lubrication may be used on the seal O.D.
Because the collar becomes distorted when
compressed,
do not re-use an old nylon collar
in the
rear bearing cover.
Apply Eaton Lubricant #71214 or equivalent to
speedometer plug O-rings, cover the entire surface. If
the electronic sensor hole has a seal, apply lubricant
#71214 or equivalent, covering the top surface.
Do not
use an O-ring with the seal.
Special Tools
Typical service tools are needed
Toolmaker’s dye
Heat lamp or hot plate and oil
Oil seal installation tool
To Assemble
1.
Use toolmaker’s dye and mark the LO range gear
for timing purposes.
Mark any two (2) adjacent teeth on the LO range
gear. Repeat the procedure for the two (2)
adjacent teeth directly opposite the first set
marked.
2.
For models so equipped, install the stepped
washer, step down.
3.
With the large diameter spline down, place the
washer on the output shaft shoulder.
4.
With LO range gear clutching teeth down, position
LO range gear on the output shaft, engage the
washer splines.
A/08-8
S/35-1
A/08-6
1
continued on next page
4
2
3
