Eaton SC100, Руководство по эксплуатации

Страница: 55 / 86

Communications
Copyright © 2008-2011 Eaton Corporation. All Rights Reserved.
IPN 997-00012-63C August 2011
49
PSTN Modem Communications
Connections

The PC modem may be external to the PC (as shown) or internal.

SC100 system controller

PC/laptop with PowerManagerII and/or DCTools.

RS232 modem cable (straight-thru). If access to
XS1 is restricted use a DB9 ribbon cable extension
(Farnell part number 869-6411).

PSTN modem

PSTN network.
SC100 Setup

Not all modems are suitable. If your modem does not operate correctly check the modem setup
string. Contact your Eaton dc product supplier or Eaton for further assistance. See Worldwide
Support on page
75 .
► To enable modem communications
1
Connect to the SC100 with DCTools (see details on page 9 ).
2
Go to Communications .
3
Click on + to expand Modem . Configure the following settings:
Enable Modem: Enabled
Modem Power Reset: Optional. If this is enabled, then the SC100 will attempt
to reset a non-operating modem by turning its power
supply off and on using digital output 2.
Modem Set Up String: The string sent to the modem on reset.
The modem AT command should not be included as it
is automatically sent. The Auto-Answer Rings
parameter is also sent, so it does not need to be
included here. For complete details of appropriate
commands, consult your modem documentation.
Modem Auto Answer Rings: Number of rings before an incoming call is answered.
Setting this parameter to zero disables incoming calls
(the modem can still be used for alarm reporting).