Eaton Rapid Link RAMO5, Руководство пользователя

Страница: 90 / 218

3 Installation
3.4 Power bus
86
Rapid Link 5 · RAMO5 · RASP5 10/19 MN034004EN www.eaton.com
3.4.1.3 End-piece mounting
▶ First slide the lower (shorter) part of busbar end piece RA-C1-END1 onto
the prepared flexible busbar.
▶ Slot the individual conductors into the insulation channels in the busbar
end piece up to the stop.
▶ Connect the top and bottom sections to the two clamping screws.
The flexible busbar meets the IP65 degree of protection when properly
installed.
3.4.1.4 Connections flexible busbar junction
The supply and outgoer modules can be installed at any point along the flexi-
ble busbar The busbar’s conductors are not interrupted. The connection is
made with contact screws.
Figure 52: Pin assignment for flexible busbar junction RA-C1-PLF1
Pin Function Conductor number
(7 x 4 mm
2
)
1 L1 1
2 L2 2
3 L3 3
4 N 4
5 +24 V
1)
5
6 0 V
1)
6
PE PE yellow/green
1) Not used for RAMO5 and RASP5.
L2 L3
N L1 PE