Eaton Rapid Link 5, Руководство пользователя, Страница: 167 / 249

7 Parameterization
7.2 Parameterization using OLED operating unit
Rapid Link 5 · RAMO5 · RASP5 05/20 MN034004EN www.eaton.com
163
7.2.3 Reset parameters (RESET)
Table 32: Resetting parameters (RESET)
7.2.4 Extended parameter set
Table 33: Open and exit the extended parameter set
Commands Description
Reset to default settings
+ +
Press the
▲
and
▼
and STOP buttons together or simultaneously and hold them down
for two seconds.
-> All parameters will be reset to their default settings.
The display will show
P-dEF
.
Reset after a fault
Press the STOP button to reset a fault message.
The display will show
StoP
.
Commands Description
Open the extended parameter set
Press the OK button and hold it down for two seconds in order to
access the parameter interface.
->
The display shows the parameter that was used last.
Use the
▲
and
▼
buttons to select parameter P1-14.
Press the OK button.
Use the
▲
or
▼
buttons to select the password set using parameter
P2-32 (Level 2, default setting 101).
Press the OK button to confirm.
-> The extended parameter set is now available.
Exit the extended parameter set
Use the
▲
and
▼
buttons to set a value for P1-14 that does not match
the password (P2-32).
Press the OK button to confirm.
-> Only the basic parameters, i.e. the parameters in the first parameter
group (P1-01 to P1-14), will now be accessible.