Eaton PowerXL, Инструкция по установке и настройке параметров

Страница: 56 / 173

3 Installation
3.3 Mounting
52
DC1-S…20…, DC1-S…OE1 Variable Frequency Drives 05/21 MN040058EN www.eaton.com
▶ First fit the screws at the specified positions, mount the variable
frequency drive and then fully tighten all screws.
Table 4: Installation dimensions, screws, tightening torques
3.3.3.2 Fixing on a mounting rail
As an alternative to screw fixing, DC1-S… variable frequency drives with
sizes FS1 and FS2 and a degree of protection of IP20 can also be mounted
on a mounting rail as per IEC/EN 60715.
Figure 25: Mounting rail conforming with IEC/EN 60715
▶ To do this, place the variable frequency drive on the mounting rail from
above [1] and press it down until it snaps into place [2].
Frame size Degree of
protection
a1 b1 Screw Tightening Torque
FS IP NEMA mm in mm in Quantity Size Nm lb-in
FS1 IP20 NEMA 0 50 1.97 170 6.69 4 M4 1 8.85
FS1 IP66 NEMA 4X 184.5 5.85 189 7.44 4 M4 1.2 - 1.5 10.62 - 13.27
FS2 IP20 NEMA 0 75 2.95 215 8.46 4 M4 1 8.85
FS2 IP66 NEMA 4X 176 6.93 200 7.87 4 M4 1.2 - 1.5 10.62 - 13.27
1 in = 1’’ = 25.4 mm; 1 mm = 0.0394 in
￫
If you use EMC mounting adapters (DX-EMC-MNT-…), use a tall
mounting rail (15 mm) preferably.
￫
If you use EMC mounting adapters (DX-EMC-MNT-…), use a tall
mounting rail (15 mm) preferably.
35
1
7.5
15
1.38”
0.04”
0.29”
0.59”