Eaton Powerware 5125, Руководство пользователя, Страница: 61 / 68

TROUBLESHOOTING
Eaton 5125 Tower UPS (1000–2200 VA) User's Guide
S
05147304 Rev C
www.eaton.com/powerquality
55
Table 9. Troubleshooting Guide (continued)
Action Possible Cause Alarm or Condition
1 beep every 4 seconds.
The UPS is on battery (see
“Battery Mode” on page 33 for
more information). The UPS is powering the equipment with
battery power. Prepare your equipment for
shutdown. During an extended power outage,
save your work and turn off your equipment to
conserve battery power.
2 beeps every 2 seconds.
The battery is running low. Three minutes or less of battery power
remains (depending on load configuration and
battery charge).
Save your work and turn off your equipment.
The alarm cannot be silenced.
The UPS is running on battery
power because the input voltage
is too high or too low. Correct the input voltage, if possible. The UPS
continues to operate on battery until the
condition is corrected or the battery is
completely discharged.
If the condition persists, the input voltage in
your area may differ from the UPS nominal.
The utility line voltage and
frequency are out of
specification. Have a qualified electrician check the wiring.
1 beep every 5 seconds.
The batteries may be fully
discharged. Plug the UPS into a power outlet for 24 hours
to charge the battery. Press and hold the
button for 3 seconds.
If the indicator is still on, see “Replacing
Batteries” on page 42.
The battery is not connected
correctly. Check the b attery connections. Call your
service representative if the problem persists.