4
Eaton Power Xpert® Gateway PXGX UPS Card Quick Start Instructions 164950240—Rev 04
Figure 4. Install the Ethernet Cable
Power Xpert Gatewa
y
PXGX UP
S
EM
P
Upstrea
m
Downstrea
m
10
0
10
0
Ac
t
Ac
t
Setu
p
Restar
t
Statu
s
DH
CP
Iden
t
Powe
r
5.
Wait for the power light and status light on the installed card to illuminate. This takes about two minutes.
6.
Open a Web browser and type the default IP address (
https://169.254.0.101
for firmware 2.6.0.0 or later,
http://192.168.200.101
for earlier firmware versions).
7.
Did the Power Xpert Gateway software open to the PXGX UPS card page?
•
If yes, the driver has already been installed automatically. Either verify the IP address assigned
through DHCP or manually enter a static (fixed) IP address for the card’s network connection:
a.
To verify the DHCP-assigned IP address, go to the
Obtain a DHCP-Assigned IP Address
section.
b.
To manually enter a fixed IP address, go to the
section.
•
If no, the driver has not been installed. Go to the
section to confirm that you
have the most current USB Driver software. If not, install or update the USB Driver software.
IInnssttaallll tthhee D
Drriivveerr S
Sooffttw
waarree
The steps you use to install the driver software depend on your operating system (OS). This procedure provides
instructions for installing driver software on a Windows OS.
NOTE
You can use either the Device Manager path or the Devices and Printers path to browse
for the driver software and install it. This procedure uses the Device Manager.
To install the driver from the
Device Manager
:
1.
Click
Start
in the Start bar. Type
Device
in the search box.
2.
Select
Device Manager
from the list above the search box. The
Device Manager
displays (see
).