Eaton Power Xpert 9395P-600/600, Инструкция по установке и эксплуатации, Страница: 113 / 226

Eaton ® Power Xpert ® 9395P-600 (300V-600V) Installation and Operation Manual 164000710—Rev 07 95
2. Unfasten the front door latch and swing the door open (see Figure 20 ).
3. Remove the right interface entry conduit landing plate to drill or punch holes (see Figure 30 ).
4. Reinstall the interface entry plate and install the conduit.
5. Route and install the LAN and other cables to the appropriate X-Slot cards. See Figure 35 and Figure 41 for
X-Slot communication bay locations.
6. Close the door and secure the latch.
7. Refer to the manual supplied with the X-Slot card for operator instructions.
Figure 41. X-Slot Communication Bays
X-Slot Communication Bay 1
X-Slot Communication Bay 2
X-Slot Communication Bay 3
X-Slot Communication Bay 4
44..1100 IInnssttaalllliinngg aa R REEP PO O S Sw wiittcchh
A latching-type Remote Emergency Power-off (REPO) switch can be used in an emergency to shut down the
UPS and remove power to the critical load from a location away from where the UPS is installed.
Figure 43
shows a REPO switch.
Installation